E27 Lamp Holder (+3 Shade Rings ) with Switch, 2mtrs Cable and Fitted UK Plug

This electrical assembly is all ready to be used. Connect the lamp holder to the utility ring, fit your bulb, then plug straight into your electrical socket and switch on and off using the inline switch..

For use with our DIY Floor and Table Lamp Making Kits and our Table and Floor Lamp Base Making Kits, the E27 Lamp Holder is fitted with an in-line switch and a UK three pin plug.

When using with our Table and Floor Lamp Base Making Kits, an extra black threaded ring is provided to fit into the opening on the assembled Table or Floor Lamp Base as pictured.

The E27 Lamp Holder is fully tested in compliance with EU legislation for health and safety.

Features

• E27 Edison screw lamp holder with two black plastic threaded rings
• 1 additional plastic threaded ring for use with our Table and Floor Lamp Base Making Kits
• 2 metres of white cable with fitted in-line switch
• Fitted UK plug with 3A fuse

Specifications

• Fully tested in compliance with EU legislation for health and safety
• For use with European utility lampshade fittings
• Cable length 2 metres in total
• Switch is spaced 75cm from lampholder fitting
• Plug is spaced 195cm from lampholder fitting
• Fully tested in compliance with EU legislation for health and safety.